tag:blogger.com,1999:blog-6812933731830029012.post3241106292521912621..comments2024-03-28T01:43:10.954-07:00Comments on RE-Xtreme RC: Yokomo DIB/DRB Steering Belcrank LockRE-Xtremehttp://www.blogger.com/profile/08499723519019132382noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-6812933731830029012.post-83340168157405160962014-07-24T03:12:40.665-07:002014-07-24T03:12:40.665-07:00as long as you have clearance. should be fine.as long as you have clearance. should be fine.RE-Xtremehttps://www.blogger.com/profile/08499723519019132382noreply@blogger.comtag:blogger.com,1999:blog-6812933731830029012.post-58880895481273950552014-07-23T17:59:58.771-07:002014-07-23T17:59:58.771-07:00no sure if my earlier question is posted...apologi...no sure if my earlier question is posted...apologise if this is double post.<br />Would like to check, in the instruction manual show m3x12mm screw, however in your STEPS by STEPS, the screw to replace is m3x10 with m3x6 + m3x3 grub screw......so the question is i should use m3x10mm instead of m3x12mm like i did(following the manual) ?Anonymoushttps://www.blogger.com/profile/06976500662509010050noreply@blogger.com